Mold Breather Gas venting ejector pin made-in-Japan A unique solution developed in Japan can help increase mould ventilation as much as 80%, reducing pressure inside the mould, power consumption, maintenance and quality defects in production.Discover more >> Pelletizer Water free air-cooled solution with low impact on environment Turn your regrind granules into virgin-like pellets. Our solution partner MSK developed a compact item that doesn´t require connection to water pipelines. The air cooling system equipped in the pelletizer has a low impact on both cost and environment, without affecting the quality of the final product.Discover more >> Magnet Stick It collects and removes ferrous metal particles from your material to improve production quality The magnet stick is a powerful tool that is at the same time versatile, and easy to use and clean. Easily added to any kind of conveying system (even retro-fit) it helps you remove ferrous material contamination from your plastic granules. The effect is a reduced defect rate and an increase of the mold life-span.Discover more >> Static Eliminator High performance to change positive electric potential to negative With its long experience in the manifacture sector, Matsui offers a long-lasting item that can adjust electric potential from positive to negative. It also can prevent re-absorption and molding defects, such as color unevenness and black spots.Discover more >> ARV Material in-line dust remover to eliminate defects A new design allows it to be installed into any material line to remove resin powder and fines, so to ensure more stable plasticizing and eliminate product-defects caused by incomplete melting.Discover more >> MAG Gas suction device to suck the gas out of the cavity The MAG-01P/-02P overcomes the issue of gases causing damages when molding resin by preventing gases from adhering to the mold. A gas vent is added to the runner part or mold of the molded product to let the gas escape. Moreover, thanks to its compact size it can be installed close to the molding unit also in the narrower spaces.Discover more >> Push Damper Material cut-off unit The Push Damper can help overcome jamming issues in your conveying hoses, as it eliminates residual material inside by cutting off the conveyed material by a constant quantity and, therefore, prevents moisture reabsorption. It´s indicated for batch conveying systems.Discover more >> SMS2 Proportional valve The proportional valve SMS2 solves your material conveying issues. With a linear-running cylinder that can switch between two material ports, it can help you convey regrind and virgin material. The movement of the valve can be controlled with a timer, and it can be asily installed anywhere thanks to its compact and convenient design.Discover more >> Vistus-R Freefall metal detection system with Separator SW The Vistus-R separator system by our partner Minibea Intec is reliable in detecting metal foreign bodies, ferrous and non-ferrous. It represents the optimal solution for high product throughput: thank to its design it prevents the product from being crushed.Discover more >>
